Code: CB7
Description: Height sensor is abnormal
Remedy: [Procedure 1] Does turning the copier’s power switch OFF then ON again rectify the trouble? Yes END No Is the wiring between the finisher controller board and the sensor normal? No Correct the wiring. Yes Is the voltage across J6-2(+) and J6-4(-) on the finisher controller board 5V DC? No Replace the finisher controller board. Yes Re-adjust the height sensor. Replace the height sensor if this trouble occurs frequently. [Procedure 2] Is connector J6 on the finisher controller board, J114 on the height sensor or relay connector J212 disconnected? Yes Re-connect the connector(s). No Is the voltage across J6-2(+) and J6-4(-) on the finisher controller board 5V DC? No Replace the finisher controller board. Yes Is the wiring between the finisher controller board and the sensor normal? No Correct the wiring. Yes Replace the height sensor. [Procedure 3] Does re-adjusting by the DIP switches rectify the trouble? Yes END No Is the wiring between the finisher controller board and the sensor normal? No Correct the wiring. Yes Is the voltage across J6-2(+) and J6-4(-) on the finisher controller board 5V DC? No Replace the finisher controller board. Yes Replace the height sensor.