Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi E01 — Toshiba e-Studio 166

Code: E01

Description: Jam not reaching the exit sensor: The paper which has passed through the fuser unit does not reach the exit sensor.
Remedy: Open the transfer cover. Is there any paper on the transport path?
YES Remove the paper.
NO Is the exit sensor working? (Perform the input check in the test mode: 03-[INTERRUPT]OFF/[9]/[5])
NO 1) Check if the connector of the exit sensor is disconnected. 2) Check if the connector CN17 on the MAIN board is disconnected. 3) Check if the connector pins are disconnected and the harnesses are open circuited. 4) Check if the conductor pattern on the MAIN board is short circuited or open circuited. 5) Replace the exit sensor. 6) Replace the MAIN board.
YES Is the registration roller clutch working? (Perform the output check in the test mode: 04-108/158)
NO 1) Check if the connector of the registration roller clutch is disconnected. 2) Check if the connector CN26 on the MAIN board is disconnected. 3) Check if the connector pins are disconnected and the harnesses are open circuited. 4) Check if the conductor pattern on the MAIN board is short circuited or open circuited. 5) Replace the registration roller clutch. 6) Replace the MAIN board.
YES 1) Check the registration roller. Replace it if it is worn out. 2) Check if the aligning amount is appropriate. An [E01] error occurs both when the amount is too large and too small.

← Xem tất cả mã lỗi Toshiba e-Studio 166

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie