Code: E02
Description: Paper exit jam Stop jam at the exit sensor: The trailing edge of the paper does not pass the exit sensor after its leading edge has reached this sensor.
Remedy: Check item: Side cover Remove the paper if there is any paper on the transport path. Exit sensor • Sensor check • Connector check (CN17, J510, and J511) • Harness check Registration roller clutch • Connector check (CN26-B, J525, and J530) • Harness check MAIN board • Board check • Connector check (CN17, CN26-B) • Harness check Paper alignment Check if the aligning amount is appropriate. An [E01] error occurs both when the amount is too large and too small.
Parts to be replaced: Exit sensor Registration roller clutch Registration roller Replace it if it is worn out. MAIN board
Parts to be replaced: Exit sensor Registration roller clutch Registration roller Replace it if it is worn out. MAIN board