Code: 911
Description: Main motor (MM) error
Remedy: 1 Turn printer off and remove right cover. Open top cover and override top cover interlock switch. Restart printer and observe main motor and photodeveloper cartridge OPC belt. Does main motor attempt to turn but OPC belt will not rotate? Replace photodeveloper cartridge. Note: Photodeveloper cartridge is a customer ordered supply. Go to step 2. 2 Observe main motor and fuser. Does main motor attempt to turn but fuser will not? Replace fuser assembly. Note: Fuser is a customer ordered supply. Go to step 3. 3 Are there any unusual noises around main motor before error posts? Replace main motor. Go to step 4. Go to step 5. 4 Does noise go away? Problem solved. Go to step 5. 5 Is cable properly connected to main motor? Go to step 6. Properly connect cable. Retest printer. If error clears, problem solved, otherwise go to step 6. 6 If waste toner bottle is removed, reinsert it. Ensure rear cover assembly cover is shut. Override top and front cover interlock switches. For location, Reconnect operator panel. Turn printer on. Allow printer to run until error posts. Disconnect connector from main motor and check the following on disconnected cable connector: Pin 4 to pin 5—24VDC Pin 6 to pin 5—24VDC Pin 10 to pin 5—5VDC Are voltages present? Replace main motor. Go to step 9. Go to step 7. 7 Remove I/O board shield. Disconnect DCN12 from I/O board. Check for continuity and shorted pins on cable that connects DCN12 to main motor. Is cable okay? Go to step 8. Replace cable. Retest printer. If error clears, problem solved, otherwise go to step 8. 8 Disconnect cable from DCN13 on I/O board. Check the following on disconnected cable connector: Pin 1 to pin 2—24VDC Pin 9 to pin 12—5VDC Are voltages present? Replace I/O board. Go step 10. Replace cable that connects ACN1 on LVPS to DCN13 on I/O board. Remove RIP board cage to gain access to cable. Go to step 9. 9 Reassemble and retest printer. Does error clear? Problem solved. Go to step 10. 10 Check cable that connects engine controller board connector I2CN to I/O board connector DCN3 for continuity and pin shorts. Is cable okay? Replace engine controller board. Replace cable.