Code: 990
Description: Transfer belt (transfer unit) error
Indicates unstable transfer belt rotation; color matching cannot be secured.
Indicates unstable transfer belt rotation; color matching cannot be secured.
Remedy: 1 Open rear cover assembly and check transfer belt unit markers for stains. Are markers stained? Clean belt marker area with cotton cloth. If problem persists go to step 2. Go to step 2. 2 Remove transfer belt unit and observe markers on side. Are belt markers deformed or does transfer belt Reinstall transfer belt unit. Go to step 3. 3 Turn printer off and remove I/O board shield. Are cables DCN13 and DCN16 properly connected to I/O board? Go to step 4. Properly connect cables. If problem persists, go to step 4. 4 Ensure rear cover assembly and front cover assembly are closed. Override top interlock switch and turn printer on. Wait until printer displays error and remove DCN16 from I/O board. Check for 5 VDC between DCN16 pin 1 (on I/O board) and ground (you can touch negative lead of voltmeter to metal bracket that holds I/O board to obtain ground.) Is voltage present and correct? I/O board is providing 5 VDC to marker sensor. Replace transfer belt marker sensor. Marker sensor is a part of bracket assembly. If problem persists, replace engine controller board. Go to step 5. 5 Reconnect DCN16 and disconnect cable from DCN13. On cable, check for 5 VDC from pin 9 to ground (you can touch negative lead of voltmeter to metal bracket that holds I/O board to obtain ground.) Is voltage present and correct? LVPS is providing 5 VDC to I/O board. Replace faulty I/O board. Replace LVPS.