Code: E73
Description: Stop jam at the exit sensor: The trailing edge of the original does not pass the exit sensor after its leading edge has reached this sensor.
Remedy: Is the exit roller stained?
YES Clean the roller. NO Is the exit sensor working? (Perform the input check: 03-[INTERRUPT]ON/[2]/[2])
NO 1) Check if the connector of the exit sensor is disconnected. 2) Check if the connector CN75 on the ADF board is disconnected. 3) Check if the connector pins are disconnected or the harnesses are open circuited. 4) Check if the conductor pattern on the ADF board is short circuited or open circuited. 5) Replace the exit sensor. 6) Replace the ADF board.
YES Replace the ADF board.
YES Clean the roller. NO Is the exit sensor working? (Perform the input check: 03-[INTERRUPT]ON/[2]/[2])
NO 1) Check if the connector of the exit sensor is disconnected. 2) Check if the connector CN75 on the ADF board is disconnected. 3) Check if the connector pins are disconnected or the harnesses are open circuited. 4) Check if the conductor pattern on the ADF board is short circuited or open circuited. 5) Replace the exit sensor. 6) Replace the ADF board.
YES Replace the ADF board.