Remedy: Setting of the equipment • Check if the finisher is set as the specified finisher on the equipment (FS-08-4548). Finisher • Check if the harness connecting the equipment and the finisher controller PC board is disconnected or open circuited. • Check if the conductor pattern on the finisher controller PC board is open circuited or short circuited. • Update the finisher firmware. LGC board • Check if the harness connecting the FIN board and the LGC board on the equipment is disconnected or open circuited. • Connector check (CN346) • Check if the conductor pattern on the LGC board is open circuited or short circuited.