Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi E9F0 — Toshiba e-Studio 2000AC

Code: E9F0

Description: Finisher jam (Puncher unit) Hole Punch Unit Jam in Finisher - Please Clear Hole Punch. [MJ-1042] Paper jam at the hole punch unit [MJ-6105] Paper jam at the hole punch unit
Causes: Punch HP sensor (S4) Punch sensor (S5) Punch motor (M3) Hole punch control PC board (HP)
Remedy: MJ-1042 (When MJ-6011 is installed)
Punch unit sliding motor abnormality Check if the electrical continuity of the coil is normal. If electricity is not conducted, replace the motor. Punch sliding unit home position sensor abnormality Measure the voltage on TP26 on the hole punch control PC board. Then check that the measured voltage is 1V or lower when not shielded and within the range of 5V+-5% when shielded. If the voltage does not fall within the range mentioned, replace the sensor. Paper detection sensor (lightreceiving/ light-emitting) (S24/ S25) Measure the voltage on 8 pin of CN6 on the hole punch control PC board. Then check that the measured voltage is 3.0V or higher when not shielded and 1.2 or lower when shielded. If the voltage does not fall within the range mentioned, replace the sensor. Faulty cables and connectors Check if the electrical continuity between the connector terminals is normal. If electricity is not conducted, replace the connector. (Hole punch control PC board: CN3, CN4, CN5, CN6, CN7) Hole punch control PC board abnormality If the error still occurs after replacing the sensor and the connector, replace the hole punch control PC board. Finisher control PC board (FIN) abnormality Replace the finisher control PC board (FIN).
MJ-1110 (When MJ-6105 is installed)
Paper Check if there is any paper on the transport path of the equipment and remove it if there is. Punch motor (M3) • Motor check • Connector check • Harness check Punch HP sensor (S4) • Sensor check • Connector check • Harness check Punch sensor (S5) • Sensor check • Connector check • Harness check Hole punch control PC board (HP) • Board check • Connector check • Harness check

← Xem tất cả mã lỗi Toshiba e-Studio 2000AC

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie