Code: EA50
Description: Finisher jam (Finisher section) Staple Jam in Finisher - Please Clear Staple. [MJ-1042] Stapling jam [MJ-1110] Stapling jam
Causes: Stapler Finisher controller PC board (FIN)
Remedy: MJ-1042 Staple unit stapling start position sensor (S17) abnormality Measure the voltage on TP23 on the finisher control PC board (FIN). Then check that the measured voltage is 1V or lower when the sensor is ON and within the range of 3.3V +- 5% when OFF. If the voltage does not fall within the range mentioned, replace the staple unit. Staple unit staple empty sensor (S18) abnormality Measure the voltage on TP24 on the finisher control PC board (FIN). Then check that the measured voltage is 1V or lower when the sensor is ON and within the range of 3.3V +- 5% when OFF. If the voltage does not fall within the range mentioned, replace the staple unit. Faulty cables and connectors Check if the electrical continuity between the connector terminals is normal. If electricity is not conducted, replace the connectors. (Finisher control PC board (FIN): CN17) Finisher control PC board (FIN) abnormality If the error still occurs after replacing the staple unit and the connectors, exchange the finisher control PC board (FIN).
MJ-1110 Stapler • Check if there is any paper in the finisher or on the transport path of the equipment or on the finishing tray. Remove it if there is • Is the jam cleared by taking off the staple cartridge from the finisher and removing the staple sheet slid from the staple case? • If the actuator of the stapler safety sensor (S11) does not move smoothly, remove its clip from the side and then reattach it. • Connector check • Harness check Finisher controller PC board (FIN) • Board check • Connector check (CN19) • Harness check
MJ-1110 Stapler • Check if there is any paper in the finisher or on the transport path of the equipment or on the finishing tray. Remove it if there is • Is the jam cleared by taking off the staple cartridge from the finisher and removing the staple sheet slid from the staple case? • If the actuator of the stapler safety sensor (S11) does not move smoothly, remove its clip from the side and then reattach it. • Connector check • Harness check Finisher controller PC board (FIN) • Board check • Connector check (CN19) • Harness check