Code: EA50
Description: Stapling jam: Stapling is not performed properly. [MJ-1022/1025]
Remedy: MJ-1022 Is there any paper remaining on the transport path in the finisher or equipment or on the stapling tray? YES Remove the paper. NO Is the jam cleared by taking off the staple cartridge from the finisher and removing the staple sheet slid from the staple case? YES End. NO Is the connector J8 on the finisher controller PC board disconnected? Is the harness connecting the finisher controller PC board and stapling home position sensor (S17) open circuited? YES Connect the connector securely. Replace the harness. NO Is the stapling home position sensor working properly? l NO 1) Connect the connector of the stapling home position sensor securely. 2) Replace the stapling home position sensor. YES Replace the finisher controller PC board. MJ-1025 Is there any paper remaining on the stapling tray? YES Remove the paper. NO Open the front door. Is the stapler home position mark blue? YES Rotate the stapler opening dial until the home position mark turns blue. NO Is any of the connectors CN11 (slide home position sensor), CN8 (stapler safety switch) and CN6 (staple/fold motor) on the finisher controller PC board disconnected? Is the stapler unit installed securely? Is the harness connecting the finisher controller PC board and slide home position sensor open-circuited? Is the harness connecting the finisher controller PC board and stapler safety switch opencircuited? YES Connect the connector securely. Replace the harness. NO Are the slide home position sensor and stapler safety switch working properly? l NO 1) Replace the stapler unit. 2) Replace the stapler safety switch. YES Replace the finisher controller PC board.