Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi F092 — Toshiba e-Studio 202L

Code: F092

Description: SRAM and NVRAM abnormality on the SYS board
Remedy: (1) Take off the FAX board if installed. (2) Turn the power OFF and start up with the Setting Mode (08). Note: Be sure to start up with the Setting Mode (08), not the normal mode immediately after the NVRAM replacement or clearing, and then perform the following steps. (3) When gNVRAM/SRAM ERROR DOES IT INITIALIZEh is displayed on the LCD, enter the number for the model type and then press the [START] button. Select g1h for a system ROM version earlier than V3.2, and g2h for V3.2 or later. (4) Check the destination displayed on the LCD and then press the [START] button. If the destination is incorrect, key in the correct number and then press the [START] button. (5) Check the destination displayed on the LCD screen and then press the [START] button. If the destination is incorrect, key in the correct number and then press the [START] button. (6) When the confirmation messege appears on the LCD screen, press the [INTERRUPT] button. (Initialization of SRAM and NVRAM will start.) (7) Perform the panel calibration (08-692). (8) Perform the counter copying (08-257 Sub-code: 1). (9) Perform the initialization at the software version upgrade (08-947). (10) Check the serial number after performing gEquipment number displayh (08-995). If the number is different from the one on the label attached to the rear cover of the equipment, enter the correct serial number again with 08-995. Note: The MAC address of the equipment is generated based on this serial number. Entering the incorrect serial number may result in an inability to access the network due to an invalid MAC address. (11) Initialize the NIC information (08-693). (12) Turn the power OFF. (13) Install the FAX board taken off in step (1). * If the FAX board has not been installed, the following steps are not necessary. (14) Start up with the Setting Mode (08). (15) Set the destinetion with gDestination setting of FAX machineh (08-701). (16) Start up with FAX Clearing Mode (1*). (17) Perform gFAX Set Uph (1*-100). (18) Turn the power OFF. (19) Turn the power ON. (20) Set the dial type. [USER FUNCTIONS] - [ADMIN] - [FAX] - [INITIAL SETUP] (21) Turn the power OFF and then back ON. If the error is not recovered, replace the NVRAM on the SYS board.

← Xem tất cả mã lỗi Toshiba e-Studio 202L

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie