Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi E510 — Toshiba e-Studio 2050c

Code: E510

Description: Jam not reaching the ADU entrance sensor: The paper does not reach the ADU entrance sensor after it is switchbacked in the exit section.
Causes: ADU entrance sensor Exit motor ADU motor LGC board ADU board Rollers in the ADU Replace it if it is worn out. Exit roller Replace it if it is worn out. Pressure spring
Remedy: Paper falling on the inner tray ADU Check if the connector between the ADU and equipment is connected. Paper jamming at the exit gate section Drawer Check that paper is not skewed in the side guides of the drawer. Change the setting value of 08-4564 from "0" to "1".Check the setting size and paper size. Example: Check if the paper size is A4 though A3 is set. Fuser Unit Check that springs are securely attached to the separation finger. Stop in the fuser unit / scratches on the leading edge of paper Fuser Unit Check if the bracket or jam releasing guide of the fuser unit is deformed. Replace it if needed. All ADU entrance sensor • Sensor check (Perform the input check: 03- [FAX]ON/[4]/[B]) • Connector check (CN338, CN440, CN441) • Harness check Exit motor • Motor check (Perform the output check: 03-121/ 171) • Connector check (CN332) • Harness check ADU motor • Motor check (Perform the output check: 03-110/ 160) • Connector check (CN338, CN440, CN445) • Harness check LGC board • Board check • Connector check (CN338) • Harness check ADU board • Board check • Connector check (CN440, CN441, CN445) • Harness check

← Xem tất cả mã lỗi Toshiba e-Studio 2050c

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie