Code: EA50
Description: Stapling jam: Stapling is not performed properly. [MJ-1031/1101]
Causes: MJ-1031 Stapler Finisher controller PC board
MJ-1101 Stapler Finisher controller PC board
MJ-1106 Stapler Finisher controller PC board
MJ-1101 Stapler Finisher controller PC board
MJ-1106 Stapler Finisher controller PC board
Remedy: MJ-1031 Stapler • Check if there is any paper in the finisher or stapler and remove it if there is • Is the jam cleared by taking off the staple cartridge from the finisher and removing the staple sheet slid from the staple case? • Connector check (J112, J113) • Harness check Finisher controller PC board • Board check • Connector check (J112, J113) • Harness check
MJ-1101 Stapler • Check if there is any paper in the finisher or on the transport path of the equipment or on the finishing tray. Remove it if there is • Is the jam cleared by taking off the staple cartridge from the finisher and removing the staple sheet slid from the staple case?(S11) • Connector check (CN2) • Harness check Finisher controller PC board • Board check • Connector check (CN2) • Harness check
MJ-1106 Stapler • Check if there is any paper in the finisher or on the transport path of the equipment or on the finishing tray. Remove it if there is • Is the jam cleared by taking off the staple cartridge from the finisher and removing the staple sheet slid from the staple case? • If the actuator of the stapler safety sensor (S11) does not move smoothly, remove its clip from the side and then reattach it. • Connector check • Harness check Finisher controller PC board • Board check • Connector check (CN19) • Harness check
MJ-1101 Stapler • Check if there is any paper in the finisher or on the transport path of the equipment or on the finishing tray. Remove it if there is • Is the jam cleared by taking off the staple cartridge from the finisher and removing the staple sheet slid from the staple case?(S11) • Connector check (CN2) • Harness check Finisher controller PC board • Board check • Connector check (CN2) • Harness check
MJ-1106 Stapler • Check if there is any paper in the finisher or on the transport path of the equipment or on the finishing tray. Remove it if there is • Is the jam cleared by taking off the staple cartridge from the finisher and removing the staple sheet slid from the staple case? • If the actuator of the stapler safety sensor (S11) does not move smoothly, remove its clip from the side and then reattach it. • Connector check • Harness check Finisher controller PC board • Board check • Connector check (CN19) • Harness check