Code: E510
Description: Jam not reaching the ADU entrance sensor: The paper does not reach the ADU entrance sensor after it is switchbacked in the exit section.
Causes: ADU entrance sensor LGC board Exit motor ADU exit sensor Exit board LGC board Rollers in the ADU Exit roller
Remedy: 1 Open the ADU. Is there any paper in front of the ADU entrance sensor? Yes Remove the paper. No 2 2 Is the ADU entrance sensor working?(Perform the input check in the test mode: 03-[FAX]OFF/[1]/ [D]) Yes 3 No • Check if the connector of the ADU entrance sensor is disconnected. • Check if the connector CN311 on the LGC board is disconnected. • Check if the connector pins are disconnected and the harnesses are open circuited. • Check if the conductor patterns on the MOT board and LGC board are short circuited or open circuited. (e-STUDIO206L/256/306) • Check if the conductor patterns on the MOT2 board and LGC board are short circuited or open circuited. (e-STUDIO356/456/506) • Replace the ADU entrance sensor. • Replace the LGC board. 3 Is the exit motor (rotating in reverse) working? (Perform the output check in the test mode: 03-121/ 171) : e-STUDIO206L/ 256/306 (Perform the output check in the test mode: 03-124/ 174) : e-STUDIO356/456/ 506 Yes 4 No • Check if the connector of the exit motor is disconnected. • Check if the connector CN431 on the MOT board is disconnected. (e-STUDIO206L/256/306) • Check if the connector CN405 on the MOT2 board is disconnected. (e-STUDIO356/456/506) • Check if the connector pins are disconnected and the harnesses are open circuited. • Check if the conductor pattern on the LGC board and MOT board is short circuited or open circuited. (e-STUDIO206L/256/306) • Check if the conductor pattern on the LGC board and MOT2 board is short circuited or open circuited. (e-STUDIO356/456/506) • Replace the exit motor. • Replace the MOT board. (e-STUDIO206L/ 256/356/506) • Replace the MOT2 board. (e-STUDIO356/ 456/506) • Replace the LGC board.