Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi E02 — Toshiba e-Studio 223

Code: E02

Description: Stop jam at the exit sensor: The trailing edge of the paper does not pass the exit sensor after its leading edge has reached this sensor.
Causes:
Remedy: Step Check Item Result Measure Next Step
1 Open the transfer cover. Is there any paper on the transport path? Yes Remove the paper. 2 No 2 Is the exit sensor working? (Perform the input check in the test mode: 03- [INTERRUPT]OFF/[9]/[5]) Yes 3 No 1. Check if the connector of the exit sensor is disconnected. 2. Check if the connector CN17 on the MAIN board is disconnected. 3. Check if the connector pins are disconnected and the harnesses are open circuited. 4. Check if the conductor pattern on the MAIN board is short circuited or open circuited. 5. Replace the exit sensor. 6. Replace the MAIN board. 3 Is the registration roller clutch working? (Perform the output check in the test mode: 04-108/158) Yes 4 No 1. Check if the connector of the registration roller clutch is disconnected. 2. Check if the connector CN26 on the MAIN board is disconnected. 3. Check if the connector pins are disconnected and the harnesses are open circuited. 4. Check if the conductor pattern on the MAIN board is short circuited or open circuited. 5. Replace the registration roller clutch. 6. Replace the MAIN board. 4 1. Check the registration roller. Replace it if it is worn out. 2. Check if the aligning amount is appropriate. (See.. P.6-6 "6.3.2 Paper alignment at the registration roller") An [E01] error occurs both when the amount is too large and too small.

← Xem tất cả mã lỗi Toshiba e-Studio 223

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie