Code: E13
Description: Drawer misfeeding (Paper not reaching the registration sensor): The paper fed from the drawer does not reach the registration sensor.
Causes:
Remedy: Step Check Item Result Measure Next Step
1 Open the transfer cover. Is there any paper in front of the registration sensor? Yes Remove the paper. 2 No 2 Is the registration sensor working? (Perform the input check in the test mode: 03- [INTERRUPT]OFF/[9]/[6]) Yes 3 No 1. Check if the connector of the registration sensor is disconnected. 2. Check if the connector CN26 on the MAIN board is disconnected. 3. Check if the connector pins are disconnected and the harnesses are open circuited. 4. Check if the conductor pattern on the MAIN board is short circuited or open circuited. 5. Replace the registration sensor. 6. Replace the MAIN board. 3 Is the pickup clutch working? (Perform the output check in the test mode: 04-201) Yes 4 No 1. Check if the connector of the pickup clutch is disconnected. 2. Check if the connector CN26 on the MAIN board is disconnected. 3. Check if the connector pins are disconnected and the harnesses are open circuited. 4. Check if the conductor pattern on the MAIN board is short circuited or open circuited. 5. Replace the pickup clutch. 6. Replace the MAIN board. 4 Check the drawer paper feed roller. Replace it if it is worn out.
1 Open the transfer cover. Is there any paper in front of the registration sensor? Yes Remove the paper. 2 No 2 Is the registration sensor working? (Perform the input check in the test mode: 03- [INTERRUPT]OFF/[9]/[6]) Yes 3 No 1. Check if the connector of the registration sensor is disconnected. 2. Check if the connector CN26 on the MAIN board is disconnected. 3. Check if the connector pins are disconnected and the harnesses are open circuited. 4. Check if the conductor pattern on the MAIN board is short circuited or open circuited. 5. Replace the registration sensor. 6. Replace the MAIN board. 3 Is the pickup clutch working? (Perform the output check in the test mode: 04-201) Yes 4 No 1. Check if the connector of the pickup clutch is disconnected. 2. Check if the connector CN26 on the MAIN board is disconnected. 3. Check if the connector pins are disconnected and the harnesses are open circuited. 4. Check if the conductor pattern on the MAIN board is short circuited or open circuited. 5. Replace the pickup clutch. 6. Replace the MAIN board. 4 Check the drawer paper feed roller. Replace it if it is worn out.