Code: E030
Description: Power-ON jam: The paper is remaining on the paper transport path when power is turned ON.
Causes: Sensor. MAIN board
Remedy: 1 Open the cover of the unit/ area whose picture is blinking on the control panel. Is there any paper on the transport path? (Refer to the following table.) Yes Remove the paper. No 2 2 Is the sensor in the jamming area working? (Perform the input check in the test mode: refer to the following table.) Yes 3 No • Check if the connector of the sensor is disconnected. • Check if any of the connectors on the MAIN board is disconnected. • Check if the connector pins are disconnected and the harnesses are open circuited. • Check if the conductor pattern on the MAIN board is short circuited or open circuited. • Replace the sensor 3 MAIN board • Replace the MAIN board.
Registration area Right cover Registration sensor 03-[A]/[A] Exit area Right cover Exit sensor 03-[A]/[B] ADU Right cover ADU paper path sensor 03-[1]/[C] PFU PFU side cover PFU drawer feed sensor 03-[4]/[A] PFP PFP side cover PFP upper drawer feed sensor 03-[1]/[E] PFP upper lower feed sensor 03-[2]/[C]
Registration area Right cover Registration sensor 03-[A]/[A] Exit area Right cover Exit sensor 03-[A]/[B] ADU Right cover ADU paper path sensor 03-[1]/[C] PFU PFU side cover PFU drawer feed sensor 03-[4]/[A] PFP PFP side cover PFP upper drawer feed sensor 03-[1]/[E] PFP upper lower feed sensor 03-[2]/[C]