Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi EA30 — Toshiba e-Studio 232

Code: EA30

Description: Power-ON jam: Paper exists at the inlet sensor when power is turned ON. [MJ-1022/1025]
Remedy: MJ-1022 Is there any paper remaining on the transport path in the finisher? YES Remove the paper. NO Is the connector J10 on the finisher controller PC board disconnected? Is the harness connecting the finisher controller PC board and inlet sensor (S2) open circuited? YES Connect the connector securely. Replace the harness. NO Is the inlet sensor working properly? (Check the movement of the actuator.) ll NO 1) Connect the connector of the inlet sensor securely. 2) Attach the actuator securely if its shaft is out of place. 3) Replace the inlet sensor. YES Replace the finisher controller PC board. MJ-1025 Is there any paper remaining on the transport path in the finisher or equipment? YES Remove the paper. NO Is the connector CN16 (inlet sensor, folding position sensor) on the finisher controller PC board disconnected? Is the connector J1007 (photosensor PC board) on the punch controller PC board disconnected? Is the harness between the finisher controller PC board and each sensor (inlet sensor, folding position sensor, and punch controller PC board open-circuited? Is the harness connecting the punch controller PC board and photosensor PC board opencircuited? YES Connect the connector securely. Replace the harness. NO Are the inlet sensor and holding position sensor working properly? Is the photosensor PC board working properly? l NO 1) Attach the actuator securely if its shaft is out of place. 2) Replace the sensor. YES Replace the finisher controller PC board. Replace the punch controller PC board.

← Xem tất cả mã lỗi Toshiba e-Studio 232

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie