Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi E550 — Toshiba e-Studio 233

Code: E550

Description: Paper remaining jam on the transport path: The paper is remaining on the transport path when printing is finished (caused by a multiple paper feeding).
Remedy: Open the cover of the unit/area whose picture is blinking on the control panel. Is there any paper on the transport path? YES Remove the paper. NO Is the sensor in the jamming area working? (Perform the input check in the test mode: refer to the following table) NO.. 1) Check if the connector of the sensor is disconnected. 2) Check if any of the connectors on the LGC board is disconnected. 3) Check if the connector pins are disconnected and the harnesses are open circuited. 4) Check if the conductor pattern on the LGC board is short circuited or open circuited. 5) Replace the sensor. 6) Replace the LGC board. YES Replace the LGC board.
Registration area Transfer cover Registration sensor 03-[FAX]ON/[2]/[A] 1st transport sensor 03-[FAX]OFF/[6]/[E] Exit area Transfer cover Exit sensor 03-[FAX]ON/[2]/[B] ADU ADU ADU entrance sensor 03-[FAX]OFF/[1]/[H] ADU exit sensor 03-[FAX]OFF/[1]/[G] Feeding area (Main unit) Side cover 2nd transport sensor 03-[FAX]OFF/[7]/[E] LCF LCF side cover LCF feed sensor 03-[FAX]OFF/[5]/[G] PFP PFP side cover PFP upper drawer feed sensor 03-[FAX]OFF/[2]/[D] PFP lower drawer feed sensor 03-[FAX]OFF/[4]/[D] Bridge unit Bridge unit Bridge unit transport sensor-1 03-[FAX]ON/[3]/[H] Bridge unit transport sensor-2 03-[FAX]ON/[3]/[E] JSP JSP cover JSP feed sensor 03-[FAX]ON/[3]/[H] OCT OCT cover OCT feed sensor 03-[FAX]ON/[3]/[H] Finisher Finisher door Sensors in the finisher -

← Xem tất cả mã lỗi Toshiba e-Studio 233

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie