Code: E03
Description: Power-ON jam: The paper remaining the paper transport path when power turned ON.
Remedy: Open the cover the unit/area whose picture blinking the control panel. there any paper the transport path? (Refer the following table.)
YES Remove the paper. Is the sensor the jamming area working? (Perform the input check the test mode: refer the following table.)
NO 1) Check if the connector of the sensor is disconnected. 2) Check if any of the connectors on the MAIN board is disconnected. 3) Check if the connector pins are disconnected and the harnesses are open circuited. 4) Check if the conductor pattern on the MAIN board is short circuited or open circuited. 5) Replace the sensor. 6) Replace the MAIN board.
YES Replace the MAIN board.
Relation between the jamming area and the corresponding sensors and covers (If a jam occurring the PFU, check the PFU board.)
Registration area Transfer cover Registration sensor 13-[04. SENSOR TEST] Exit area Transfer cover Exit sensor 13-[04. SENSOR TEST] PFU PFU side cover PFU feed sensor 13-[04. SENSOR TEST]
YES Remove the paper. Is the sensor the jamming area working? (Perform the input check the test mode: refer the following table.)
NO 1) Check if the connector of the sensor is disconnected. 2) Check if any of the connectors on the MAIN board is disconnected. 3) Check if the connector pins are disconnected and the harnesses are open circuited. 4) Check if the conductor pattern on the MAIN board is short circuited or open circuited. 5) Replace the sensor. 6) Replace the MAIN board.
YES Replace the MAIN board.
Relation between the jamming area and the corresponding sensors and covers (If a jam occurring the PFU, check the PFU board.)
Registration area Transfer cover Registration sensor 13-[04. SENSOR TEST] Exit area Transfer cover Exit sensor 13-[04. SENSOR TEST] PFU PFU side cover PFU feed sensor 13-[04. SENSOR TEST]