Code: E74
Description: Stop jam the reverse sensor: The trailing edge the original does not pass the reversal sensor after its leading edge has reached this sensor. (RADF)
Remedy: Are the read roller and reverse roller stained?
YES Clean the rollers. Is the reverse sensor working? (Perform the input check: 13-[04. SENSOR TEST])
NO 1) Check if the connector of the reverse sensor is disconnected. 2) Check if the connector CN4 on the RADF board is disconnected. 3) Check if the connector pins are disconnected or the harnesses are open circuited. 4) Check if the conductor pattern on the RADF board is short circuited or open circuited. 5) Replace the reverse sensor. 6) Replace the RADF board.
YES Replace the RADF board.
YES Clean the rollers. Is the reverse sensor working? (Perform the input check: 13-[04. SENSOR TEST])
NO 1) Check if the connector of the reverse sensor is disconnected. 2) Check if the connector CN4 on the RADF board is disconnected. 3) Check if the connector pins are disconnected or the harnesses are open circuited. 4) Check if the conductor pattern on the RADF board is short circuited or open circuited. 5) Replace the reverse sensor. 6) Replace the RADF board.
YES Replace the RADF board.