Code: E21
Description: PFU drawer transport jam (Paper not reaching the registration sensor): The paper does not reach the registration sensor after has passed the PFU feed sensor.
Remedy: Open the transfer cover. there paper front the registration sensor?
YES Remove the paper. Is the registration sensor working? (Perform the input check the test mode: 13-[04. SENSOR TEST]
NO 1) Check if the connector of the registration sensor is disconnected. 2) Check if the connector CN26 on the MAIN board is disconnected. 3) Check if the connector pins are disconnected and the harnesses are open circuited. 4) Check if the conductor pattern on the MAIN board is short circuited or open circuited. 5) Replace the registration sensor. 6) Replace the MAIN board
YES Are the PFU transport clutches (High speed/Low speed) working? (Perform the output check the test mode: 04-203, 205)
NO 1) Check if the connectors of the PFU transport clutches (High speed/ Low speed) are disconnected. 2) Check if the connector CN4 on the MAIN board is disconnected. 3) Check if the connector pins are disconnected and the harnesses are open circuited. 4) Check if the conductor pattern on the MAIN board is short circuited or open circuited. 5) Replace the PFU transport clutches (High speed/Low speed). 6) Replace the MAIN board
YES 1) Check the condition of the pickup roller of paper source, and replace it if it is worn out. 2) Check the transport roller. Replace it if it is worn out.
YES Remove the paper. Is the registration sensor working? (Perform the input check the test mode: 13-[04. SENSOR TEST]
NO 1) Check if the connector of the registration sensor is disconnected. 2) Check if the connector CN26 on the MAIN board is disconnected. 3) Check if the connector pins are disconnected and the harnesses are open circuited. 4) Check if the conductor pattern on the MAIN board is short circuited or open circuited. 5) Replace the registration sensor. 6) Replace the MAIN board
YES Are the PFU transport clutches (High speed/Low speed) working? (Perform the output check the test mode: 04-203, 205)
NO 1) Check if the connectors of the PFU transport clutches (High speed/ Low speed) are disconnected. 2) Check if the connector CN4 on the MAIN board is disconnected. 3) Check if the connector pins are disconnected and the harnesses are open circuited. 4) Check if the conductor pattern on the MAIN board is short circuited or open circuited. 5) Replace the PFU transport clutches (High speed/Low speed). 6) Replace the MAIN board
YES 1) Check the condition of the pickup roller of paper source, and replace it if it is worn out. 2) Check the transport roller. Replace it if it is worn out.