Code: E010
Description: Paper exit jam Paper Ejection Jam - Please Clear Paper Path. Paper not reaching the exit sensor jam
Causes: Separation finger of the fuser unit Transfer belt Transfer belt unit Exit sensor LGC board
Remedy: Paper jamming immediately after the removal and installation of the transfer belt unit. Transfer belt unit Check if the transfer belt unit is installed properly. "4.7.3 Transfer belt unit (TBU)" Paper jamming at separation finger in the Fuser Unit. Fuser unit Clean the separation finger. Check if the fingers or springs of the separation finger are securely attached. Replace the separation finger. Paper separation failure at separation finger in the Fuser Unit Fuser unit • Paper tranceport check Drawer Check that paper is not skewed in the side guides of the drawer. Leading edge margin Adjust the margin with FS-05-4402 (Leading edge position adjustment) to "Color: 5.5 mm". Widen the margin if needed. (Specification Black: 4.2 mm / Color: 5 mm) • Use A3/LD paper • It is easy to check skew with a copy of a solid image (about 10 mm on its leading edge). "[C] Secondary scanning data writing start position". Paper jamming at separation finger in the Fuser Unit. Fuser unit Clean the separation finger. Check if the fingers or springs of the separation finger are securely attached. Replace the separation finger. The leading edge of paper has no scratches and the paper stops before being fused. Fuser unit Check that the pressure release screw of the pressure roller is securely tightened and pressure is properly applied. Transfer belt Replace the transfer belt. Replace the transfer belt unit. Paper folded in one side and fused during duplex printing Check if toner adheres to the fuser entry guide. Clean it if needed. All Exit sensor • Sensor check (Perform the input check: FS-03- [ALL]OFF/[9]/[C]) • Connector check • Harness check LGC board • Board check • Connector check (CN342) • Harness check