Code: E020
Description: Paper exit jam Paper Ejection Jam - Please Clear Paper Path. Paper stopping at the exit sensor jam
Causes: Separation finger of the fuser unit Exit sensor LGC board
Remedy: Paper jamming at separation finger in the Fuser Unit. Fuser unit Clean the separation finger. Check if the fingers or springs of the separation finger are securely attached. Replace the separation finger. Paper separation failure at separation finger in the fuser unit Fuser unit • Paper tranceport check Drawer Check that paper is not skewed in the side guides of the drawer. Leading edge margin Adjust the margin with FS-05-4402 (Leading edge position adjustment) to "Color: 5.5 mm". (Specification Black: 4.2 mm / Color: 5 mm) • Use A3/LD paper • It is easy to check skew with a copy of a solid image (about 10 mm on its leading edge). "[C] Secondary scanning data writing start position". Scratches on the leading edge of paper Check if toner adheres to the exit gate. Clean it if needed. All Self-diagnosis code Change the setting value of FS-08-4542 (Switching for incorrect size jam detection) from ¡§1¡- (Disabled) to ¡§0¡-(Enabled). Exit sensor • Sensor check (Perform the input check: FS-03- [ALL]OFF/[9]/[C]) • Actuator check • Connector check • Harness check LGC board • Board check • Connector check (CN342) • Harness check