Code: EA24
Description: Finisher jam (Finisher section) Paper Jam in Finisher - Please Clear Paper Path. [MJ-1110] Paper stopping jam (between the entrance and transport sensors):
Causes: Transport path switching solenoid (SOL5) Entrance sensor (S1) Transport sensor (S2) Entrance motor (M1) Finisher control PC board (FIN)
Remedy: Paper Check if there is any paper in the finisher or on the transport path of the equipment and remove it if there is. Pinch roller arm Check the position of pinch roller arm. If it is down, fix its mechanism. Transport path switching solenoid (SOL5) • Check that the gap between the transfer guide surface and the upper surface of the flapper tip is in the acceptable range according to the status of the transport path switching solenoid (SOL5) (solenoid OFF: 1.5 to 2.1 mm, solenoid ON: 2.3 to 2.9 mm). If it is not, adjust it. • Check the harness between the transport path switching solenoid (SOL5) and the finisher controller board (CN1). If there is any abnormality, correct it. Entrance sensor (S1) • Sensor check • Connector check • Harness check Transport sensor (S2) • Sensor check • Connector check • Harness check Entrance motor (M1) • Motor check • Connector check • Harness check Finisher control PC board (FIN) • Board check • Connector check (CN8, CN17) • Harness check