Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi E020 — Toshiba e-Studio 2505AC

Code: E020

Description: Paper stopping at the exit sensor jam
Causes: Separation finger of the fuser unit Reverse gate solenoid Exit sensor LGC board
Remedy: Paper jamming at separation finger in the Fuser Unit. Fuser unit Clean the separation finger. Check if the fingers or springs of the separation finger are securely attached. Replace the separation finger. Paper separation failure at separation guide in the fuser unit Fuser unit • Paper transport check • Check the gap between the separation guide and fuser belt. "6.12.1 Adjustment of the Separation Guide Gap" Drawer Check that paper is not skewed in the side guides of the drawer. Leading edge margin Adjust the margin with FS-05-4402 (Leading edge position adjustment) to "Color: 5.5 mm". (Specification Black: 4.2 mm / Color: 5 mm) • Use A3/LD paper • It is easy to check skew with a copy of a solid image (about 10 mm on its leading edge). Refer to "[D] Secondary scanning data writing start position". Scratches on the leading edge of paper Check if toner adheres to the exit gate. Clean it if needed. Paper stopped in the reverse section Reverse gate solenoid • Solenoid check (Perform the output check: FS- 03-222, 03-223) • Connector check (CN301, J609, J610) • Harness check All Self-diagnosis code Change the setting value of FS-08-4542 (Switching for incorrect size jam detection) from 1 (Disabled) to 0(Enabled). Exit sensor • Sensor check (Perform the input check: FS-03- [ALL]OFF/[9]/[C]) • Actuator check • Connector check • Harness check LGC board • Board check • Connector check (CN329, CN306) • Harness check

← Xem tất cả mã lỗi Toshiba e-Studio 2505AC

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie