Description: [MJ-1042] Paper stopping jam (stop command request)
Causes: Finisher control PC board (FIN) LGC board (LGC)
Remedy: MJ-1042 Finisher • Check if the harness connecting the equipment and the finisher control PC board is disconnected or open circuited. • Check if the conductor pattern on the finisher controller PC board is open circuited or short circuited. • Update the finisher firmware. • Replace the finisher control PC board. LGC board • Check if the harness connecting the finisher and the LGC board on the equipment is disconnected or open circuited. • Connector check • Check if the conductor pattern on the LGC board is open circuited or short circuited. • Replace the LGC board.