Code: E010, E020
Description: [E010] Leading edge of paper not reaching the exit sensor [E020] Trailing edge of paper not passing the exit sensor
Causes: Exit sensor MAIN board Registration roller clutch Registration roller
Remedy: 1 Open the right cover. Is there any paper on the transport path? Yes Remove the paper. No 2 2 Is the exit sensor working? (Perform the input check in the test mode: 03-[A]/ [B]) Yes 3 No • Check if the connector of the exit sensor is disconnected. • Check if the connector CN10 on the MAIN board is disconnected. • Check if the connector pins are disconnected and the harnesses are open circuited. • Check if the conductor pattern on the MAIN board is short circuited or open circuited. • Replace the exit sensor • Replace the MAIN board 3 Is the registration roller clutch working? (Perform the output check in the test mode: 03-108/ 158) Yes 4 No • Check if the connector of the registration roller clutch is disconnected. • Check if the connector CN22 on the MAIN board is disconnected. • Check if the connector pins are disconnected and the harnesses are open circuited. • Check if the conductor pattern on the MAIN board is short circuited or open circuited. • Replace the registration roller clutch. • Replace the MAIN board. 4 Registration roller • Check the registration roller. Replace it if it is worn out.