Code: E130
Description: 1st drawer misfeeding. Jam not reaching the registration sensor
Causes: MAIN board Upper drawer feed clutch Upper drawer feed roller Separation roller
Remedy: 1 Open the right cover. Is there any paper on the transport path? Yes Remove the paper. No 2 2 Is the drawer feed clutch working? (Perform the output check in the test mode: 03-201) Yes 4 No • Check if the connector of the drawer feed clutch is disconnected. • Check if the connector CN22 on the MAIN board is disconnected. • Check if the connector pins are disconnected and the harnesses are open circuited. • Check if the conductor pattern on the MAIN board is short circuited or open circuited. • Replace the drawer feed clutch. • Replace the MAIN board. 3 1st drawer feed roller Separation roller • Check the drawer feed roller and separation roller. Replace them if they are worn out.