Code: E130
Description: 1st drawer misfeeding (Paper not reaching the 1st transport sensor): The paper fed from the 1st drawer does not reach the 1st transport sensor.
Causes: 1st transport sensor. LGC board 1st drawer feed clutch 1st drawer feed roller 1st drawer separation roller 1st drawer pickup roller
Remedy: 1 Open the Automatic duplexing unit. Is there any paper in front of the 1st transport sensor? Yes Remove the paper. No 2 2 Is the 1st transport sensor working? (Perform the input check in the test mode: FS-03- [ALL]OFF/[9]/[B]) Yes 3 No • Check if the connector of the 1st transport sensor is disconnected. (J661, J659) • Check if the connector CN318 on the LGC board is disconnected. • Check if the connector pins are disconnected and the harnesses are open circuited. • Check if the conductor pattern on the LGC board is short circuited or open circuited. • Replace the 1st transport sensor. • Replace the LGC board. 3 Is the 1st drawer feed clutch working? (Perform the output check in the test mode: FS-03- 201) Yes 4 No • Check if the connector of the 1st drawer feed clutch is disconnected. (J666) • Check if the connector CN316 on the LGC board is disconnected. • Check if the connector pins are disconnected and the harnesses are open circuited. • Check if the conductor pattern on the LGC board is short circuited or open circuited. • Replace the 1st drawer feed clutch. • Replace the LGC board. 4 1st drawer feed roller Separation roller Pickup roller • Check the 1st drawer feed roller, separation roller and pickup roller. Replace them if they are worn out.