Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi EA50 — Toshiba e-Studio 2540c

Code: EA50

Description: Stapling jam: Stapling is not performed properly. [MJ-1031/1101]
Causes: MJ-1031 Stapler Finisher controller PC board
MJ-1101 Stapler Finisher controller PC board
MJ-1106 Stapler Finisher controller PC board
Remedy: MJ-1031 Stapler • Check if there is any paper in the finisher or stapler and remove it if there is • Is the jam cleared by taking off the staple cartridge from the finisher and removing the staple sheet slid from the staple case? • Connector check (J112, J113) • Harness check Finisher controller PC board • Board check • Connector check (J112, J113) • Harness check
MJ-1101 Stapler • Check if there is any paper in the finisher or on the transport path of the equipment or on the finishing tray. Remove it if there is • Is the jam cleared by taking off the staple cartridge from the finisher and removing the staple sheet slid from the staple case?(S11) • Connector check (CN2) • Harness check Finisher controller PC board • Board check • Connector check (CN2) • Harness check
MJ-1106 Stapler • Check if there is any paper in the finisher or on the transport path of the equipment or on the finishing tray. Remove it if there is • Is the jam cleared by taking off the staple cartridge from the finisher and removing the staple sheet slid from the staple case? • If the actuator of the stapler safety sensor (S11) does not move smoothly, remove its clip from the side and then reattach it. • Connector check • Harness check Finisher controller PC board • Board check • Connector check (CN19) • Harness check

← Xem tất cả mã lỗi Toshiba e-Studio 2540c

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie