Code: CB10
Description: Transport motor abnormality: The transport motor or stack transport roller is not rotating normally. [MJ-1025]
Remedy: MJ-1025 MJ-1025 Is the stack feed roller (upper) home position sensor (PI12) working properly? NO Replace the sensor. YES Is the wiring between the finisher controller PC board and feed motor (M1) correct? NO Correct the wiring. YES Try turning the stack feed roller (upper) shaft by hand. Does the stack feed roller (upper) move up/down normally? NO Fix the mechanism. YES Try replacing the feed motor (M1). Is the problem corrected? YES End. NO Replace the finisher controller PC board.
MJ-1101 Is there any mechanical problem when the entrance roller is rotated? ..YES Fix the mechanism. NO Is the harness between the entrance motor (M1) and the finisher control PC board (CN7) disconnected or open circuited? l ..YES • Reconnect the connector securely. • Replace the harness. NO 1. Replace the entrance motor (M1). 2. Replace the finisher control PC board.
MJ-1101 Is there any mechanical problem when the entrance roller is rotated? ..YES Fix the mechanism. NO Is the harness between the entrance motor (M1) and the finisher control PC board (CN7) disconnected or open circuited? l ..YES • Reconnect the connector securely. • Replace the harness. NO 1. Replace the entrance motor (M1). 2. Replace the finisher control PC board.