Description: Stop jam at the read sensor: The trailing edge of the original does not pass the read sensor after its leading edge has reached this sensor.
Remedy: 1. Clean the read roller if it is stained. 2. Is the read sensor working? (Perform the input check: 03-[FAX]ON/[7]/[G]) * If it is working properly, proceed to 6. If not, check 3 to 5 below. 3. Check if the connector CN75 on the RADF board is disconnected from the read sensor or the harnesses are open circuited. Correct if any. 4. Replace the read sensor. 5. Replace the RADF board. 6. Replace the read roller if it is worn out.