Code: EA30
Description: Power-ON jam: Paper exists at the inlet sensor when power is turned ON.
Remedy: MJ-1025 1. Check if there is any paper remaining in the Finisher or the Saddle Stitch Finisher or on the transport path of the equipment. Remove if there is. 2. Check if the connector pins are disconnected or the harnesses are open circuited between the inlet sensor and the connector on the finisher controller PC board. Correct if there is any abnormality. 3. Check if the harnesses are open circuited between the punch controller PC board and the photosensor PC board. Correct if there is any abnormality. 4. Are the inlet sensor, folding position sensor and photosensor PC board working properly? (Correct if the actuator does not return normally or if it is deformed 5. Replace the sensors. 6. Replace the finisher controller PC board. 7. Replace the punch controller PC board.
MJ-1024 1. Check if there is any paper in the finisher or on the transport path of the equipment and remove it if there is. 2. Check if the connectors J707, J708 and J722B on the finisher controller PC board are disconnected from the corresponding sensor (inlet sensor [P133], transport path sensor [P134] and processing tray sensor [P138] ) or the harnesses are open circuited. Correct if any. 3. Is each of the sensors (the inlet sensor, the transport path sensor and the processing tray sensor) working properly? (Check the movement of the actuator.) 4. Replace the sensors. 5. Replace the finisher controller PC board.
MJ-1031 1. Check if there is any paper in the finisher or on the transport path of the equipment and remove it if there is. 2. Check if the connector J104 on the finisher controller PC board is disconnected from the inlet sensor (SR2) or the harnesses are open circuited. Correct if any. 3. Is the inlet sensor working properly? (Check the movement of the actuator.) 4. Replace the inlet sensor. 5. Replace the finisher controller PC board.
MJ-1024 1. Check if there is any paper in the finisher or on the transport path of the equipment and remove it if there is. 2. Check if the connectors J707, J708 and J722B on the finisher controller PC board are disconnected from the corresponding sensor (inlet sensor [P133], transport path sensor [P134] and processing tray sensor [P138] ) or the harnesses are open circuited. Correct if any. 3. Is each of the sensors (the inlet sensor, the transport path sensor and the processing tray sensor) working properly? (Check the movement of the actuator.) 4. Replace the sensors. 5. Replace the finisher controller PC board.
MJ-1031 1. Check if there is any paper in the finisher or on the transport path of the equipment and remove it if there is. 2. Check if the connector J104 on the finisher controller PC board is disconnected from the inlet sensor (SR2) or the harnesses are open circuited. Correct if any. 3. Is the inlet sensor working properly? (Check the movement of the actuator.) 4. Replace the inlet sensor. 5. Replace the finisher controller PC board.