Code: EAB0
Description: Saddle paper transport stop jam: The paper which passed through the inlet sensor does not reach or pass through the folding position sensor. [MJ-1025]
Remedy: MJ-1025 Is there any paper remaining on the paper transport path in the saddle stitcher section in the finisher? YES Remove the paper. NO Is the connector CN16 (folding position sensor) on the finisher controller PC board disconnected? Is the harness connecting the finisher controller PC board and folding position sensor opencircuited? YES Connect the connector securely. Replace the harness. NO Is the folding position sensor working properly? NO Replace the sensor. YES Replace the finisher controller PC board.
MJ-1024 1. Check if there is any paper in the finisher, saddle stitcher or the on the transport path of the equipment. Remove it if there is. 2. Is either of the connectors J9, J10, J13, J21 on the saddle stitcher controller PC board disconnected? 3. Is the harness between the saddle stitcher controller PC board and each sensor (saddle inlet sensor [PI22], vertical path paper sensor [PI17], No.1 paper sensor [PI18], No.2 paper sensor [PI19], No.3 paper sensor [PI20] and the delivery sensor [PI11]) open circuited? 4. Is each of the sensors (the saddle inlet sensor, No.1 paper sensor, No.2 paper sensor, No.3 paper sensor, vertical path paper sensor and the delivery sensor) working properly? (Check the movement of the actuator.) 5. Replace the sensor. 6. Replace the saddle stitcher controller PC board.
MJ-1024 1. Check if there is any paper in the finisher, saddle stitcher or the on the transport path of the equipment. Remove it if there is. 2. Is either of the connectors J9, J10, J13, J21 on the saddle stitcher controller PC board disconnected? 3. Is the harness between the saddle stitcher controller PC board and each sensor (saddle inlet sensor [PI22], vertical path paper sensor [PI17], No.1 paper sensor [PI18], No.2 paper sensor [PI19], No.3 paper sensor [PI20] and the delivery sensor [PI11]) open circuited? 4. Is each of the sensors (the saddle inlet sensor, No.1 paper sensor, No.2 paper sensor, No.3 paper sensor, vertical path paper sensor and the delivery sensor) working properly? (Check the movement of the actuator.) 5. Replace the sensor. 6. Replace the saddle stitcher controller PC board.