Code: E940
Description: Stop jam at the bridge unit transport sensor 2: The trailing edge of the paper does not pass the bridge unit transport sensor 2 after its leading edge has reached the bridge unit transport sensor 2.
Causes: Bridge unit transport sensor-2 (exit sensor) LGC board
Remedy: Bridge unit transport sensor-2 (exit sensor) • Sensor check (Perform the input check: 03-[ALL]OFF[0]/[B]) • Connector check (CN354, J802, J1011) • Harness check LGC board • Board check • Connector check (CN354, J1011) • Harness check Bridge unit • Does the transport roller of the bridge unit work when the fuser motor is rotated? (Perform the output check: 03-113/163) • Check the drive system of the equipment and bridge unit. • Check if the rollers in the exit roller, the pressure spring and the bridge unit are worn out.