Description: Stop jam at the original registration sensor: The trailing edge of the original does not pass the original registration sensor after its leading edge has reached this sensor.
Causes: Registration sensor RADF board Registration roller Replace it if it is worn out. Original width detection sensor-1 Original width detection sensor-2
Remedy: Registration roller Clean the registration roller if it is stained. Registration sensor • Sensor check (Perform the input check: 03-[FAX] ON[7]/[H]) • Connector check (J86, J88) • Harness check RADF board • Board check • Connector check (CN74) • Harness check Original width detection sensor-1 • Sensor check (Perform the input check: 03-[FAX] ON[8]/[F]) • Connector check (J94) • Harness check Original width detection sensor-2 • Sensor check (Perform the input check: 03-[FAX] ON[8]/[G]) • Connector check (J94) • Harness check