Code: E140
Description: Lower drawer misfeeding (Paper not reaching the 2nd transport sensor): The paper fed from the lower drawer does not reach the 2nd transport sensor.
Causes: 2nd transport sensor LGC board Lower drawer feed clutch Lower drawer feed roller Separation roller Pickup roller
Remedy: 1 Open the feed cover. Is there any paper in front of the 2nd transport sensor? Yes Remove the paper. No 2 2 Is the 2nd transport sensor working? (Perform the input check in the test mode: 03- [FAX]OFF/[7]/[A]) Yes 3 No • Check if the connector of the 2nd transport sensor is disconnected. • Check if the connector CN316 on the LGC board is disconnected. • Check if the connector pins are disconnected and the harnesses are open circuited. • Check if the conductor pattern on the LGC board is short circuited or open circuited. • Replace the 2nd transport sensor. • Replace the LGC board. 3 Is the lower drawer feed clutch working? (Perform the output check in the test mode: 03-202) Yes 4 No • Check if the connector of the lower drawer feed clutch is disconnected. • Check if the connector CN315 on the LGC board is disconnected. • Check if the connector pins are disconnected and the harnesses are open circuited. • Check if the conductor pattern on the LGC board is short circuited or open circuited. • Replace the lower drawer feed clutch. • Replace the LGC board. 4 Lower drawer feed roller Separation roller Pickup roller • Check the lower drawer feed roller, separation roller and pickup roller. Replace them if they are worn out.