Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi E580 — Toshiba e-Studio 256SE

Code: E580

Description: Stop jam at the reverse sensor: The trailing edge of the paper does not pass the reverse sensor after its leading edge has reached this sensor
Causes: Reverse sensor LGC board Exit roller Reverse motor MOT2 board
Remedy: 1 Checking of paper • Open the ADU and remove paper if there is any on the transport path. * If the error still occurs, check the following: 2 2 Is the reverse sensor working? (Perform the input check in the test mode: 03-[FAX]ON/[9]/[C]) Yes 3 No - Check if the connector pins are disconnected or the harnesses are open circuited between the reverse sensor and the connector CN304 on the LGC board. Correct if there is any abnormality. - Replace the reverse sensor. - Replace the LGC board. 3 Is the reverse motor working? (Perform the output check in the test mode: 03-123/173) Yes Check the exit roller. Replace it if it is worn out. No • Check if the connector pins are disconnected or the harnesses are open circuited between the reverse motor and the connector CN304 on the LGC board (and also the connectors CN401 and CN406 on the MOT2 board). Correct if there is any abnormality. • Replace the reverse motor. • Replace the MOT2 board. • Replace the LGC board.

← Xem tất cả mã lỗi Toshiba e-Studio 256SE

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie