Code: E010
Description: Jam not reaching the exit sensor: The paper which has passed through the fuser unit does not reach the exit sensor.
Remedy: Open the jam access cover. Is there any paper on the transport path? ↓→ YES → 1) Remove the paper. 2) Check if the intermediate guide is installed properly. (Ch.4.4 *c10) NO Is the paper clinging to the transfer belt entering under the receiving tray? → YES → Remove the paper. NO Is the intermediate guide installed properly? (Ch.4.4 *c10) → NO → Install the intermediate guide correctly. YES Is there any paper jammed in the fuser unit? ↓→ YES → 1) Remove the paper. 2) Check if there is any abnormality on the paper transport path. NO Is the exit sensor working? (Perform the input check: 03-[FAX]OFF/[7]/[H]) ↓→ NO → 1) Check if the connector of the exit sensor is disconnected. 2) Check if the connector CN334 on the LGC board is disconnected. 3) Check if the connector pins are disconnected or the harnesses are open circuited. 4) Check if the conductor pattern on the LGC board is short circuited or open circuited. 5) Replace the exit sensor. 6) Replace the LGC board. YES Is the registration clutch working? (Perform the output check: 03-108/158) ↓→ NO → 1) Check if the connector of the registration clutch is disconnected. 2) Check if the connector CN339 on the LGC board is disconnected. 3) Check if the connector pins are disconnected or the harnesses are open circuited. 4) Check if the conductor pattern on the LGC board is short circuited or open circuited. 5) Replace the registration clutch. 6) Replace the LGC board. YES Check the registration roller. Replace it if it is worn out.