Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi E320 — Toshiba e-Studio 281c

Code: E320

Description: PFP upper drawer transport jam (Paper not reaching the 2nd drawer feed sensor): The paper does not reach the 2nd drawer feed sensor after it has passed the PFP upper drawer feed sensor.
Remedy: Open the side cover. Is there paper in front of the lower drawer feed sensor? → YES → Remove the paper. NO Is the lower drawer feed sensor working? (Perform the input check: 03-[FAX]ON/[3]/[G]) ↓→ NO → 1) Check if the connector of the lower drawer feed sensor is disconnected. 2) Check if the connector CN338 on the LGC board is disconnected. 3) Check if the connector pins are disconnected or the harnesses are open circuited. 4) Check if the conductor pattern on the LGC board is short circuited or open circuited. 5) Replace the lower drawer feed sensor. 6) Replace the LGC board. YES Are the lower transport clutches working? (Perform the output check: 03-203, 205) ↓→ NO → 1) Check if the connectors of the lower transport clutches (high/low speed) are disconnected. 2) Check if the connector CN341 on the LGC board is disconnected. 3) Check if the connector pins are disconnected or the harnesses are open circuited. 4) Check if the conductor pattern on the LGC board is short circuited or open circuited. 5) Replace the lower transport clutches (high/low speed). 6) Replace the LGC board. YES When the paper fed from the PFP: Is the PFP transport clutch working? (Perform the output check: 03-225) ↓→ NO → 1) Check if the connector of the PFP transport clutch is disconnected. 2) Check if any of the connectors CN241, CN242 and CN244 on the PFP board is disconnected. 3) Check if the connector CN344 on the LGC board is disconnected. 4) Check if the connector pins are disconnected or the harnesses are open circuited. 5) Check if the conductor patterns on the PFP board and LGC board are short circuited or open circuited. 6) Replace the PFP transport clutch. 7) Replace the PFP board. 8) Replace the LGC board. YES 1) Check the condition of the feed roller, separation roller and pickup roller of each paper source, and replace them if they are worn out. 2) Check the transport roller. Replace it if it is worn out.

← Xem tất cả mã lỗi Toshiba e-Studio 281c

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie