Description: Transport delay jam: The paper which has reached the inlet sensor does not pass through the inlet sensor. [MJ-1024]
Remedy: MJ-1024 Is there any paper remaining on the transport path in the finisher, saddle stitcher section or equipment? → YES → Remove the paper. NO Is the connector J708 on the finisher controller PC board disconnected? Is the harness connecting the finisher controller PC board and inlet sensor (PI33) open circuited? → YES → Connect the connector securely. Replace the harness. NO Is the inlet sensor working properly? (Check the movement of the actuator.) ↓→ NO → 1) Connect the connector of the sensor securely. 2) Attach the actuator securely if its shaft is out of place. 3) Replace the sensor. YES Replace the finisher controller PC board.