Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi E010 — Toshiba e-Studio 3005AC

Code: E010

Description: Paper not reaching the exit sensor jam
Causes: Separation finger of the fuser unit Transfer belt Transfer belt unit Exit sensor LGC board PFC board Registration motor
Remedy: Paper jamming immediately after the removal and installation of the transfer belt unit. Transfer belt unit Check if the transfer belt unit is installed properly. "4.7.3 Transfer belt unit (TBU)" Paper separation failure at separation guide in the Fuser Unit Fuser unit • Paper transport check • Check the gap between the separation guide and fuser belt. "6.12.1 Adjustment of the Separation Guide Gap" Drawer Check that paper is not skewed in the side guides of the drawer. Leading edge margin Adjust the margin with FS-05-4402 (Leading edge position adjustment) to "Color: 5.5 mm". Widen the margin if needed. (Specification Black: 4.2 mm / Color: 5 mm) • Use A3/LD paper • It is easy to check skew with a copy of a solid image (about 10 mm on its leading edge). Refer to "[D] Secondary scanning data writing start position". Paper jamming at separation finger in the Fuser Unit. Fuser unit Clean the separation finger. Check if the fingers or springs of the separation finger are securely attached. Replace the separation finger. The leading edge of paper has no scratches and the paper stops before being fused. Fuser unit Check that the pressure release screw of the pressure roller is securely tightened and pressure is properly applied. Transfer belt Replace the transfer belt. Replace the transfer belt unit. Paper folded in one side and fused during duplex printing Check if toner adheres to the fuser entry guide. Clean it if needed. All Exit sensor • Sensor check (Perform the input check: FS-03- [ALL]OFF/[9]/[C]) • Actuator check • Connector check • Harness check LGC board • Board check • Connector check (CN329, CN306, CN316, CN327, CN305) • Harness check PFC board • Board check • Connector check (CN452, CN465) • Harness check Aligning amount If the aligning amount is too small, a skew, an image dislocation in the feeding direction, E010 (a paper jam occurring between the registration pass sensor and the paper clinging detection sensor) may happen. If the aligning amount is too large, on the other hand, an abnormal noise (paper-folding noise) or actual paper folding may occur. Confirm that the value of the aligning amount is appropriate. Refer to ƒt P. 6-8 "6.1.6 Paper alignment at the registration roller".

← Xem tất cả mã lỗi Toshiba e-Studio 3005AC

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie