Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi E020 — Toshiba e-Studio 3040c

Code: E020

Description: Stop jam at the exit sensor: The trailing edge of the paper does not pass the exit sensor after its leading edge has reached this sensor.
Causes: Separation plate of the fuser unit Separation finger of the fuser unit Exit sensor LGC board
Remedy: Paper jamming at separation finger in the Fuser Unit. Fuser unit Clean the separation finger. Check if the fingers or springs of the separation finger are securely attached. Replace the separation finger. Paper separation failure at separation plate in the fuser unit Fuser unit • Check the gap between the separation plate and the fuser belt. (Refer to "6.7.4 Gap adjustment for separation plate".) • Paper tranceport check Drawer Check that paper is not skewed in the side guides of the drawer. Leading edge margin Adjust the margin with 05-4402 (Leading edge position adjustment) to "Color: 5.5 mm". (Specification Black: 4.2 mm / Color: 5 mm) • Use A3/LD paper • It is easy to check skew with a copy of a solid image (about 10 mm on its leading edge). Refer to "6.1.1 Image Related Adjustment". Scratches on the leading edge of paper Check if toner adheres to the exit gate. Clean it if needed. All Self-diagnosis code Change the setting value of 08-4542 (Switching for incorrect size jam detection) from “1” (Disabled) to “0”(Enabled). Exit sensor • Sensor check (Perform the input check: 03- [FAX]ON/[1]/[B]) • Actuator check • Connector check • Harness check LGC board • Board check • Connector check (CN333) • Harness check

← Xem tất cả mã lỗi Toshiba e-Studio 3040c

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie