Code: CB60
Description: Stapler unit shift motor abnormality: The stapler unit shift motor is not rotating normally or the Stapler Unit is not moving normally. [MJ-1025] Stapler shift motor abnormality: Stapler shift motor is not rotating or staple unit is not moving normally. [MJ-1024/ 1101]
Remedy: MJ-1025 Is the slide home position sensor (PI18) working properly? NO Replace the sensor controller PC board. YES Is the wiring between the finisher controller PC board and slide motor correct? NO Correct the wiring. YES Is there any mechanical problem with the stapler stand motion path? YES Fix the mechanism. NO Try replacing the slide motor (M8). Is the problem corrected? YES End. NO Replace the finisher controller PC board.
MJ-1024 Is the stapler shift home position sensor (PI40) working normally? NO Replace the sensor. YES Is the wiring between the finisher controller PC board and the stapler shift motor (M35) correct? NO Correct the wiring. YES Is there any mechanical problem with the stapler stand motion path? YES.. Fix the lift mechanism. NO 1. Replace the stapler shift motor. 2. Replace the finisher controller PC board.
MJ-1101 Is there any mechanical problem when the stapler is moved? ..YES Fix the mechanism. NO Is the harness between the stapler unit shift motor (M4) and the finisher control PC board (CN5) disconnected or open circuited? l ..YES • Reconnect the connector securely. • Replace the harness. NO 1. Replace the stapler unit shift motor (M4). 2. Replace the finisher control PC board.
MJ-1024 Is the stapler shift home position sensor (PI40) working normally? NO Replace the sensor. YES Is the wiring between the finisher controller PC board and the stapler shift motor (M35) correct? NO Correct the wiring. YES Is there any mechanical problem with the stapler stand motion path? YES.. Fix the lift mechanism. NO 1. Replace the stapler shift motor. 2. Replace the finisher controller PC board.
MJ-1101 Is there any mechanical problem when the stapler is moved? ..YES Fix the mechanism. NO Is the harness between the stapler unit shift motor (M4) and the finisher control PC board (CN5) disconnected or open circuited? l ..YES • Reconnect the connector securely. • Replace the harness. NO 1. Replace the stapler unit shift motor (M4). 2. Replace the finisher control PC board.