Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi EA31 — Toshiba e-Studio 3055C

Code: EA31

Description: Paper transport remaining jam in the Finisher: Paper is detected in the entrance path sensor or middle path sensor when the power is turned ON or the cover is closed. [MJ-1036] Transport path paper remaining jam: Paper is detected by the transport sensor when the power is turned ON. [MJ-1107/1108]
Causes: Transport sensor Entrance sensor Paper position sensor Finisher controller PC board
MJ-1108 Entrance sensor Feeding sensor Paper position sensor Transport sensor Finisher control PC board
Remedy: MJ-1036 Entrance path sensor (S19) abnormality Measure the voltage on TP86 on the finisher control PC board (FIN). Then check that the measured voltage is 1V or lower when not shielded and within the range of 3.3V±5% when shielded. If the voltage does not fall within the range mentioned, replace the sensor. Middle path sensor (S7) abnormality Measure the voltage on TP84 on the finisher control PC board (FIN). Then check that the measured voltage is 1V or lower when not shielded and within the range of 3.3V±5% when shielded. If the voltage does not fall within the range mentioned, replace the sensor. Sub-path sensor (S8) abnormality Measure the voltage on TP85 on the finisher control PC board (FIN). Then check that the measured voltage is 1V or lower when not shielded and within the range of 3.3V±5% when shielded. If the voltage does not fall within the range mentioned, replace the sensor. Faulty cables and connectors Check if the electrical continuity between the connector terminals is normal. If electricity is not conducted, replace the connector. (Finisher control PC board (FIN): CN6, CN22) Finisher control PC board (FIN) abnormality If the error still occurs after replacing the sensor and the connector, exchange the finisher control PC board (FIN).
MJ-1107 Transport sensor • Sensor check (S2) • Connector check (CN22) • Harness check Entrance sensor • Sensor check (S1) • Connector check (CN7, CN22) • Harness check Paper position sensor • Sensor check (S6-1, S6-2) • Connector check (CN1, CN2) • Harness check Finisher controller PC board • Borad check • Connector check (CN22) • Harness check
MJ-1108 All Finisher Check if there is any paper in the finisher or on the transport path of the equipment and remove it if there is. Entrance sensor (S1) • Sensor check • Connector check • Harness check Feeding sensor (S22) • Sensor check (S22) • Connector check (CN8) • Harness check Paper position sensor • Sensor check (S6-1, S6-2) • Connector check (CN1, CN2) • Harness check Transport sensor (S2) • Sensor check • Connector check • Harness check Finisher control PC board (FIN) • Board check • Connector check (CN6) • Harness check

← Xem tất cả mã lỗi Toshiba e-Studio 3055C

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie