Code: EAB0
Description: Paper transport jam in Saddle Stitch Finisher: Paper transport jam in Saddle Stitch Finisher [MJ-1108]
Causes: Junction box paper detection sensor (S26) Feeding sensor (S22) Transport path-2 (S27) Transport path-3 (S28) Ejecting roller (S29) Entrance motor (M1) Transport path switching solenoid (SOL9) Interface PC board (I/F) Saddle stitcher controller board Finisher controller board
Remedy: Finisher, saddle stitcher • Check if there is any paper in the finisher, saddle stitcher or the on the transport path of the equipment. Remove it if there is. • Use paper accepted in the specifications. Paper Do not use the paper longer than the specification. Transport roller Fix any mechanical problem occurring when the transfer roller is rotated. Feeding sensor (S22) • Sensor check(S22) • Connector check • Harness check Junction box paper detection sensor (S24) • Sensor check(S24) • Connector check(CN8) • Harness check Transport path-2 (S27) • Sensor check(S27) • Connector check(CN20) • Harness check Transport path-3 (S28) • Sensor check(S28) • Connector check(CN20) • Harness check Ejecting roller sensor(S29) • Sensor check(S29) • Connector check(CN20) • Harness check Transport path switching solenoid (SOL5) Check that the gap between the transfer guide surface and the upper surface of the flapper tip is in the acceptable range according to the status of the transport path switching solenoid (SOL5) (solenoid OFF: 1.5 to 2.1 mm, solenoid ON: 2.3 to 2.9 mm). If it is not, adjust it. Entrance motor (M1) • Motor check(M1) • Connector check(CN26) • Harness check Interface PC board (I/F) • Board check • Connector check(CN1, CN2, CN5, CN7, CN8) • Harness check Saddle stitcher controller board • Board check • Connector check(CN10, CN13, CN20) • Harness check