Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi CB80 — Toshiba e-Studio 306SE

Code: CB80

Description: Backup RAM data abnormality: Abnormality of checksum value on finisher controller PC board is detected when the power is turned ON. [MJ-1101/MJ-1106] EEPROM data abnormality: An error occurs during the writing of data into the EEPROM of the Finisher. [MJ- 1032/MJ-1033]
Causes: MJ-1101/MJ-1106 Finisher controller PC board
MJ-1032 Finisher control PC board (FIN) abnormalit Replace the finisher control PC board (FIN) as the cause is a fault in the IC of the backup RAM.
MJ-1033 Finisher control PC board (FIN) abnormality Replace the finisher control PC board (FIN) as the cause is a fault in the IC of the backup RAM.
Remedy: MJ-1101/MJ-1106 Finisher related service call Backup RAM data abnormality: Abnormality of checksum value on finisher controller PC board is detected when the power is turned ON.
MJ-1032 EEPROM Data readout check is performed after data writing and the result of the data readout check does not conform to the written data. The equipment does not enter the ready status after the specified time has passed from data writing.
MJ-1033 Back-up memory Data readout check is performed after data writing and the result of the data readout check does not match with the written data. The equipment does not enter the ready status after the specified time has passed from data writing.
MJ-6008 Hole punch control PC board (HP) abnormality If the behavior in the hole punch RAM check mode is not normal, replace the hole punch control PC board (HP).

← Xem tất cả mã lỗi Toshiba e-Studio 306SE

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie