Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi E140 — Toshiba e-Studio 306SE

Code: E140

Description: Lower drawer misfeeding (Paper not reaching the 2nd transport sensor): The paper fed from the lower drawer does not reach the 2nd transport sensor.
Causes: 2nd transport sensor LGC board Lower drawer feed clutch Lower drawer feed roller Separation roller Pickup roller
Remedy: 1 Open the feed cover. Is there any paper in front of the 2nd transport sensor? Yes Remove the paper. No 2 2 Is the 2nd transport sensor working? (Perform the input check in the test mode: 03- [FAX]OFF/[7]/[A]) Yes 3 No • Check if the connector of the 2nd transport sensor is disconnected. • Check if the connector CN316 on the LGC board is disconnected. • Check if the connector pins are disconnected and the harnesses are open circuited. • Check if the conductor pattern on the LGC board is short circuited or open circuited. • Replace the 2nd transport sensor. • Replace the LGC board. 3 Is the lower drawer feed clutch working? (Perform the output check in the test mode: 03-202) Yes 4 No • Check if the connector of the lower drawer feed clutch is disconnected. • Check if the connector CN315 on the LGC board is disconnected. • Check if the connector pins are disconnected and the harnesses are open circuited. • Check if the conductor pattern on the LGC board is short circuited or open circuited. • Replace the lower drawer feed clutch. • Replace the LGC board. 4 Lower drawer feed roller Separation roller Pickup roller • Check the lower drawer feed roller, separation roller and pickup roller. Replace them if they are worn out.

← Xem tất cả mã lỗi Toshiba e-Studio 306SE

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie