Code: EA25
Description: Paper transport jam (after paper stack exit): The finishing tray paper detection sensor detects paper after a stack of paper exits from the finishing tray. [MJ-1101/MJ-1106] Paper transport jam in the Finisher (after paper stack exit): Paper is detected in the finishing tray sensor after the paper stack has exited from the finishing tray. [MJ-1032] Paper transport jam in the Finisher (after paper stack exit): (1) Paper is detected in the finishing tray sensor after the paper stack has exited from the finishing tray. (2) Paper cannot be detected in the gripper arm exit sensor after the paper stack has exited from the finishing tray. [MJ-1033]
Causes: MJ-1101 Entrance sensor Transport sensor Finisher contoller PC board
MJ-1106 Entrance sensor (S1) Transport sensor (S2) Processing tray sensor (S12) Assist arm motor (M10) buffer tray guide motor (M2) Finisher control PC board (FIN)
MJ-1106 Entrance sensor (S1) Transport sensor (S2) Processing tray sensor (S12) Assist arm motor (M10) buffer tray guide motor (M2) Finisher control PC board (FIN)
Remedy: MJ-1101 Entrance sensor • Sensor check(S1) • Connector check (CN7, CN22) • Harness check Transport sensor • Sensor check(S2) • Connector check (CN7, CN22) • Harness check
MJ-1106 Finisher Check if there is any paper in the finisher or on the transport path of the equipment and remove it if there is. Entrance sensor (S1) • Sensor check • Connector check • Harness check Transport sensor (S2) • Sensor check • Connector check • Harness check Processing tray sensor (S12) • Sensor check • Connector check • Harness check Paper holding cam Is there any mechanical problem when the paper holding cam is rotated? Assist arm motor (M10) • Motor check • Connector check • Harness check Buffer tray guide Open and close the buffer tray guide. If there is any mechanical problem, fix its mechanism. buffer tray guide motor (M2) • Motor check • Connector check • Harness check Finisher control PC board (FIN) • Board check • Connector check (CN6, CN13, CN11, CN18, CN26) • Harness check
MJ-1106 Finisher Check if there is any paper in the finisher or on the transport path of the equipment and remove it if there is. Entrance sensor (S1) • Sensor check • Connector check • Harness check Transport sensor (S2) • Sensor check • Connector check • Harness check Processing tray sensor (S12) • Sensor check • Connector check • Harness check Paper holding cam Is there any mechanical problem when the paper holding cam is rotated? Assist arm motor (M10) • Motor check • Connector check • Harness check Buffer tray guide Open and close the buffer tray guide. If there is any mechanical problem, fix its mechanism. buffer tray guide motor (M2) • Motor check • Connector check • Harness check Finisher control PC board (FIN) • Board check • Connector check (CN6, CN13, CN11, CN18, CN26) • Harness check